BMW E30 air vent fix for loose vents, E34, Z3:

A common problem with the aging BMW E30, E34 and Z3 is that the interior air vents get loose and always rest in the down position.  Over time the plastic vents dry out, they expand and contract thousands of times and they lose their tight tolerances needed for them to properly function.  There is a very simple and cheap fix for this however that will change your life.

What you need:

Head to the local hardware store and get a total of eight nylon washers, two needed for each vent; four vents total.  Internal diameter needs to be .21 inches.  If the inside diameter is a little too small you can always ream them out to a proper diameter with a drill bit at home since they are only soft nylon.  We used #10 nylon washers and they fit perfect.

What is the process?

Remove the air vents (refer to the images below for further clarification).  This can be tricky and frustrating but once you do one, the rest should take no time at all.  There are essentially two tabs on each end of the vent which they rotate around.  You need to wedge in a flat head screw driver (tape the tip to make sure not scratch anything) or a plastic pry tool which you see in the picture below.  Make sure to have the vent facing all the way down, I found this makes them pop out easier.  I started with inserting the pry tool closest to the dial that opens and closes the vent.  Not sure why this side starts things off easier but it did for me.  You will need a good amount of pressure to compress the vent and push outward.  Keep working it until one side pops out.

After one side is done, move to the other side and repeat.  Make sure to put a little inward pressure on the other side of the vent with your hand to make sure it doesn't want to snap back in place.  You may even want to use a little hooked pick tool to pull the vent towards you as you pry sideways to pop the little tabs off the vent on the other side.

Clean your air vent ducts once removed:

Once the vents are removed, you may notice a lot of dirt in the ducts and on the back of the vent itself.  Now would be a great time to clean these buggers out as the vents probably have never been removed in 25+ years.  I soaked them in a bucket of soapy water for a few hours to soften up the gunk and sprayed them with a high-pressure hose after wards.  It took all of that gunk right off no problem.  

Install the plastic washers:

While the vents are drying, take your eight washers and install them on the little tabs on the vent side as seen in the pictures below.  Depending on how loose your vents are you may only need one washer per vent.  My vents were extremely sloppy so I added one washer per post.  Make sure the washers are butted all the way up to the wall of the duct, you don't want a gap.  This will make reinstallation of the vents easier.

Reinstall the air vents:

Simply reinstall the vents in reverse order and jump for joy.  You finally have working vents as if this thing just rolled off the assembly line.  It is a simple and cheap fix but it is one of the best bang for the buck modifications you can do out and the final result is absolute perfection.

Where can I learn more pro tips and informational reference guides on the BMW E30?

Learn more by clicking HERE

BMW Antenna Delete Plug Product Information:

- Plug and play installation.
- Naturally seals / water proofs antenna cutout.
- Requires no use of sealant or modification to OEM cutout.
- Locking tabs snap plug in place with fingertip pressure.
- 1,000+ sold world wide
- Fits ALL E23, E24, E28, E30, E36 and Z3 models

100% Customer Satisfaction:

"Fits perfect, high quality and good seal, worth the money" - maidenfan909
"Fast shipping great product tight firm fit" - rufu-donni
"Item as described. well packaged" - granpall
"Fast shipper and good product! Thank you!" - jtdurrett

 

$14.99 $9.99

Will it fit?

Ensure your antenna cutout has not been modified and is the OEM diameter.  An unmodified cutout will measure approximately .85 inches (2.16 cm)  in diameter.

BMW E30 3 series 1984 thru 1992

Every model coupe or sedan

BMW E36 3 series 1992 thru 1999

Every model

BMW Z3 1995 thru 2002

Every model roadster (coupes not included)

BMW E28 5 series 1981 thru 1988

Every model

Why won't a plug from the hardware store work for 50 cents?

These plugs are hard plastic and do not seal the cutout without adding silicone adhesive.  Also, these plugs are designed for American Standard cutout size and not intended to fit in a German metric size hole.

What sets our antenna plug apart from competitors?

When you purchase our product you will have 100% satisfaction guaranteed, we are confident this is the best solution to your problem.

We stand behind our product, if you don't like it, return it for a full refund.  No questions asked.

We provide the ONLY self sealing plug on the market. Our plug is the highest of quality, co-molding two types of plastic. One plastic seals the other creates a tight fit.

Most orders will ship same or next business day.

 

$14.99 $9.99

Where can I learn more BMW pro tips?

Learn more BMW information by clicking HERE